1. Because this filling machine is an automatic machine, the sizes of the easy-to-pull bottles, bottle pads, and bottle caps are all required to be uniform.

2. Before starting production, you must first test the machine with the panel manual mode (jog/handle rocker) to see if there is any abnormality in its rotation, and start production after confirming that it is normal.

3. When adjusting the machine, the tools should be used properly. It is strictly forbidden to use too large tools, use too much force to dismantle parts and knock parts hard so as not to damage the parts or affect the performance of the machine.

4. Whenever the machine is adjusted (including but not limited to shutdown maintenance, long-term shutdown), be sure to tighten the loose or found loose screws, adjust to manual mode after the adjustment check is correct, and check whether the machine action meets the requirements , to resume production.

5. The small water bottling filling machine must be kept clean. It is strictly forbidden to have oil, liquid medicine or glass debris on the machine, so as not to cause damage to the machine. Therefore, it is necessary to:
(1) During the production process of the machine, remove the liquid medicine or glass debris in time.
⑵Clean each part of the surface of the machine once before shifting over, and add clean lubricating oil with the correct label to the oiling place of each moving part.
(3) Scrub it once a week, especially clean the places that are not easy to clean in normal use or blow it with compressed air.